06-04-07, 01:20 PM
|
#1 |
|
BassFishin.Com Active Member
Join Date: Feb 2007
Location: Elliston, VA
Posts: 446
|
Making your own Lead Heads
I am looking to getting into making my own jig heads. I am looking at getting a melting pot, ingots, hooks etc. I think it will be fun as well as cost effective. I just wanted to see what you guys thought about it and if you do it or done it what tips you may have
__________________
H.G.: No. What I did to those men, after I tracked them down? That's the worst pain you can experience. |
|
|
|
06-04-07, 05:01 PM
|
#2 |
|
BassFishin.Com Veteran Member
Join Date: Jul 2006
Location: Raleigh, NC
Posts: 826
 |
It's not cost effective at the start, that's for sure, but it is fun!
The best piece of advice I can give is to be SAFE, screw all the other crap, be SAFE. If you have any questions, i'll be glad to help. |
|
|
|
|
06-04-07, 05:29 PM
|
#3 |
|
BassFishin.Com Active Member
Join Date: Feb 2007
Location: Elliston, VA
Posts: 446
|
Thanx Dampeoples I will give you a hollar if any probs arise.
__________________
H.G.: No. What I did to those men, after I tracked them down? That's the worst pain you can experience. |
|
|
|
 |
|
Disclosure / Disclaimer
Before acting on the content posted, you should know that BassFishin.Com may benefit financially and otherwise from content, advertising, links or otherwise from anything you click on, read, or look at on our website. Click here to read our Disclosure Policy and Disclaimer. |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
