Electrical problems with johnson outboard

Willvdh1 · 09-04-09, 03:21 PM

First of all the engine is a Johnson 30 early 90's model and I am having alot of trouble getting one of the cylinders to fire. I am not getting a spark to one of them. I purchased a power pack and installed it still nothing, no spark. I then tried the old pull start and then was able to get a spark.. When I put everything back down and tightened everything up, I went to start it from the ignition and again no spark. I've also replaced the sensor assembly as well as the coil and lamination assembly Any ideas??

FAQ
Members List
Social Groups	Members List	Search	Today's Posts	Mark Forums Read

09-04-09, 03:21 PM	#1
Willvdh1 BassFishin.Com Member Join Date: May 2009 Location: Georgetown, Texas Posts: 74	Electrical problems with johnson outboard First of all the engine is a Johnson 30 early 90's model and I am having alot of trouble getting one of the cylinders to fire. I am not getting a spark to one of them. I purchased a power pack and installed it still nothing, no spark. I then tried the old pull start and then was able to get a spark.. When I put everything back down and tightened everything up, I went to start it from the ignition and again no spark. I've also replaced the sensor assembly as well as the coil and lamination assembly Any ideas??

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)