Quote:
Originally Posted by ran24
Hey guys got a question for ya. I have a minnkota powerdrive v2 trolling motor that I would like to mount a transducer to. However I dont know how to go about it. The motor shaft runs through a collar of sorts and there is no room for the transducer wire. Any suggestions? Has anyone done one like this before? Thanks in advance for any info
|
I've seen some other post on other forums where people asked the same question they said there is a grove in the shaft for the cable to run through. I'm not sure if it's on all models of the powerdrives but it is on the terrova's.