Finally took the Kayak out.

[WaffleJaw]

One thing I dont like already is laying rods between my legs when I need to adjust, grab something,or retie..I was constantly worried about kicking one over board and I spend too much time making these rods.

I also dont think I would like a rod holder up front or on the trac..I wanted something simple, low profile,and out of the way...So this is what I worked on last night using an old Berkley rod holder I had laying around.

parts:
Green Faberware cutting board , Rod holder foam pulled out and cut in half, Nylon 1/4'' spacer , and a small piece of eva foam (to cover the nylon spacer for aesthetic reasons only)....(not pictured) 1/4'' SS bolt, slide trac nut, two part 10 minute FC epoxy)




I traced the foam on the board and cut it out with a jig saw leaving a lip for the bolt to go through..Sanded and drill small,shallow holes in it in hopes it will better bond with the epoxy...Once fitted and glued,I clamped it till the epoxy set.


Then just drill a 1/4'' hole in the lip...Dremmel and file the bolt to size,add the spacer,and done!..Nice little rod holder for the trac.



I like it cause the rod handle fits nicely with how the seat is designed on the Ride...I still put a strap for the handle up there as well for cheap insurance,but this should work nicely for my needs..

Oh and I started making a simple cart last night with plans I got off Palmetto Kayak.com,and some old wheels off a edger.