06-07-08, 12:49 PM
|
#1 |
|
BassFishin.Com Active Member
Join Date: Mar 2008
Location: Iowa
Posts: 184
|
Making ratttless crankbaits
I have a clear rapala square bill crank that I want to use in clear water, but I don't want it to rattle. There is only one ball-bearing in it, so I was thinking about drilling a small hole and putting apoxy or superglue in the hole to hold the ball-bearing in place. I was wondering if this single ball-bearing also helped give the bait action, and if I glued it if it would alter the action so much it didn't swim right. Do any guys or gals have any tips or advice on making a quiet crankbait?? Thanks and good fishin
|
|
|
|
Disclosure / Disclaimer
Before acting on the content posted, you should know that BassFishin.Com may benefit financially and otherwise from content, advertising, links or otherwise from anything you click on, read, or look at on our website. Click here to read our Disclosure Policy and Disclaimer. |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Threaded Mode