04-06-07, 01:58 PM
|
#1 |
|
BassFishin.Com Active Member
Join Date: Jan 2007
Posts: 113
|
Trim Hesitates
on my mercury 90 hp,new on 1994..its on my nitro ..
when i tilt motor up it hesitates at about half way up when i am lifting to put the motor brace thing on.. the only thing i did was change the fluid last year..i filled the fluid in the all way up position until it just ran out the fill hole.. any ideas.also it makes like a clicking noise going up and wine..is that normal when lifting out of water? |
|
|
|
04-06-07, 03:21 PM
|
#2 |
|
BassFishin.Com Premier Elite
Join Date: Jan 2004
Location: denton nc
Posts: 13,441
|
mine has a 2 stage cylinder it go's from 2 push rods to a single long one. you may notice that the upper stage lifts faster..
rule of thumb with a trim unit DO NOT mess with it or fill it unless it does not work at ALL.. zooker
__________________
the godfather.. aml in remission since 7-20-09 |
|
|
|
|
04-06-07, 03:48 PM
|
#3 | |
|
BassFishin.Com Active Member
Join Date: Jan 2007
Posts: 113
|
Quote:
could different fluid make difference.. it almost acts to me like a seal went and is allowing air into it, only guess.. |
|
|
|
|
 |
|
Disclosure / Disclaimer
Before acting on the content posted, you should know that BassFishin.Com may benefit financially and otherwise from content, advertising, links or otherwise from anything you click on, read, or look at on our website. Click here to read our Disclosure Policy and Disclaimer. |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Linear Mode
