How to Make Feathered Trebles Tutorial by ib

[islandbass]

Hey guys, I just put this together a bit hurriedly. I want to make it as clear as possible so if you have any input that would maximize clarity, I would appreciate it. Thanks! Tutorial below:

By Alexander Arceo (islandbass)

This purpose of this tutorial is to demonstrate how I dress treble hooks with feathers and other materials such as bucktail, flashabou, or other materials. I am not an expert. I am a relative newbie to making them. This tutorial was put together to with the hope of sharing with the reader the steps I take to make dressed trebles based on my experience making them to date.

Tools Used:
Fly Tying Vise – Nothing fancy. The one I use is a cheap, low-tech sub $20 vise
From Left to Right:
Hair Stacker (Optional)
Bobbin
Threader
Bodkin
Trebles

Dressing Materials Used and Other Items:
Head Cement (glue)
Dressing Items: Feathers (chicken feathers preferred), Flashabou, Bucktail*, etc.
Thread for tying (size 6/0)
Small plastic grocery bag
Napkin





*Only flashabou and feathers were used in this tutorial.


Preparation of Tools and Hook

1) Securing Vise to Table and Treble to Vise
Now that you have everything you need, set up your vise and secure the hook. The hook should be fastened to the vise in the bend somewhere between the hook’s shank and the barb. The jaws of the vise should not cover the barb.




Note: If you are married and value the hard work that your wife does to keep the house clean, I highly recommend you do this in the garage. Dressing trebles and other fly tying materials is a guaranteed way to make a mess.

2) Preparing Bobbin with Thread
Add the spool of thread to the bobbin. Then insert the threader through the bobbin’s long narrow cylinder.
Put the thread between the wires of the threader and pull the threader out of the cylinder.
If done correctly, the thread will have been pulled through the bobbin.

Preparation of the Materials

3) Sizing the Materials
I like to cut the materials to size that I am going to tie first. In this case it means cutting the feathers and flashabou to length. I won’t go into detail, but the alternative would take up more time

There is no real science as to what length you should cut the materials. As a rule of thumb, the bigger the hook the longer the material should or could be. I “eyeball” everything I cut. This is something that you will gain through experience.

Preparing the feathers

Once again there is no real science for preparing the feathers. I have learned that it is best to cut the thickest part of the feather’s stem off. It is easier to work with the part of the feather where the stem is thinner. The length of the feather is up to the tier. The feathers in this tutorial were cut to approximately twice the length of the treble.





In the picture above, you can see that the bottom of the feather’s stem is clear of feathers. This is the part of the feather that will be tied to the treble. While you can use scissors to trim unwanted feathers, I find it easier to tear off the feathers by hand. It also looks cleaner.

When the feather is laid on the treble, make sure that this stem does not extend passed the hook’s shank and eye meet. The thread will not cover any part of the feather’s stem above the shank.


Preparing the Flashabou
The Hair Stacker is not necessary but it can come in handy to help put the bucktail or flashabou tips on the same plane. In the picture below, I am placing the flashabou in the hair stacker




Place the flashabou into the barrel of the hair stacker and bang the base of the stacker on the table a few times. The material will slide down the stacker until it reaches bottom of the stacker. Turn the stacker on its side and remove the base. The exposed hair tips will be even.

Let’s Get to Tying

4) Adding Thread to the Hook

Hold the thread in one hand and place it on top of the shank about one-third of the way from the bottom hook’s eye. While holding the thread to the shank (pull thread downward), take the bobbin with the other hand and begin wrapping the thread onto the shank toward the eye of the hook about 10-15 times. Then, start wrapping the thread back to the point where you started the wrap. The thread should be fairly secure to the shank. Cut off the excess.




5) Adding the Materials to the Hook

Take just a little of the flashabou and place it between two of the treble’s bend. The end of the flashabou should not extend past the eye of the hook. You will not be able to cover any material passing the shank with the thread.



Grab the bobbin and carefully begin wrapping the thread around the shank toward the hook’s eye. Next, wrap back to the starting point. If you have realized that wrapping toward the hook’s eye and back is the basic procedure to follow when tying, you’re definitely correct! In the picture below you can see that the flashabou has been tied on and the bobbin is back in the starting position.

Repeat this process to add the flashabou to the two remaining sides.




Note: Not all vises are equal. More expensive vises can rotate the treble to tie the other sides without removing the hook. I do not have this luxury with my vise so I rotate the treble by removing it from the vise and fastening the next side.


Repeat the same procedure to tie on the feathers




Above, the flashabou has been tied to all three sides and the first feather.



After you finish tying the materials in, complete the wrapping process by bringing the thread to the point just under the hook’s eye as shown in the photo above.

The next step is to tie the Whip Finish by hand. It is actually very easy to tie. Unfortunately, it is very difficult for me to describe. So please refer to the link below and watch the Hand Whip Finish video. I believe it is also downloadable.

I would like to thank the folks at flyfisherman.com for what I believe is the finest how to video in tying the Whip Finish.

http://www.flyfisherman.com/ftb/jbwhip/


After you tie the Whip Finish, cut off the unneeded thread.



6) Sealing the Deal

The last step is to add the Head Cement (glue) to secure the knot and wrapped thread.

Add some glue to the bodkin’s tip. The bodkin is the thin, long, pointed shaft I am holding in my right hand.




I start by applying cement to the area where the whip finish was tied. The image below is a close up of this area. Next, I cover the thread inside the hook’s eye. Finally, the rest of the thread is covered with cement.
Use the napkin to wipe off the excess glue from the bodkin.




Spread the cement carefully and evenly with the bodkin. Allow the cement to dry. It will take just a few minutes. You may place the treble back into the vise to dry.
Congratulations, you are finished!!



I thank my daughter and son for their help in putting this together. They were instrumental in helping me cut the materials and taking the photos. Thank you for reading. Hope this helps you to get started in making your own dressed trebles. Now go on and shake your tail feather!


-Alexander Arceo

[crankybait]

great tutorial IB, props

[JB]

IB, thanks, that took a lot of time n effort to report...killer looking hackle ya made there, hope ya get a big un!

[Jim80]

as always ib killer info thanks

[BigBassin144]

Very nice IB, just one thing.... I blame you for the money I'm gonna go spend on more stuff now. just kiddin, I did always want to get into dressing hooks and maybe making hairjigs and such.

BB

[Jim80]

oh no bb better get a pad lock for your wallet . lol

[Bass'n'cast]

great job, but i do have to ask are those pokemon cards?!!? hehe, i remember those days.....

[islandbass]

My daughter started collecting them recently. I didn't even realize they were there!

[Jim80]

ib i was just gonna bring up the cards i was looking at the pictures and my son yelled pokeman cards , wait till she gets th yugioh bug then magic the gathering i played both for years was ranked nationally in yugioh and traveled for all the tournaments luckily my team had backing from a local card shop and we didn't pay to travel . but my point was it's not a bad hobby for a kid to have it teaches them math and social skills and there is worse they could be doing . as towards me i'm strictly a poker player now .

[BigBassin144]

I remember Yugioh. I've got a shoebox full of them, quite a few good ones too. Looking back, I wish I woulda saved my money for fishing stuff. I've also got a bunch of pokemon cards, but we never knew how to play the dumb game, we just collected the cards.




BB

[Jim80]

trust me i feel the same way at one point i had about 15,000 worth of cards

[islandbass]

Yeah, she's getting into the collecting aspect of it. I read the game instructions once and realized I am going to have to re-read them. Whatever happened to simple games like D & D and Chess?

[Jim80]

never caught d&d but i am certified to judge yugioh , the V.S. system and World of warcraft trading card games through upper deck . i also can throw tournaments and am certified in player management but whatever . Best advice learn to play it with her it may be cheesy but it's quality time and thats all that matters . my oldest is just starting to play yugioh now and well it's frustrating to teach him but he loves it and i am starting to have the tournament nightmare all over , from player to on looker how times change huh .

[BigBassin144]

We never played by the official rules with the sacrificing and all that junk. we just put our strongest cards into our decks and faught. it was much more fun that way.

BB