05-15-04, 10:38 AM | #1 |
BassFishin.Com Member
|
Minnkota Maxxum 74 problems
2 problems i've come across with the maxxum74 tm's.
#1:the switch on the side of the foot pedal goes bad.i usually carry a spare.you can buy a switch from ace hardware(around$10.00)it's the same switch but cheaper than from minnkota.i've replaced 2 on mine already and i know Billy had to replace his.the problem seems to be caused by running the tm in cruise on full for extended periods.it's a simple fix.you'll have to remove the bottom plate and then theres a little plate covering the connections on the switch.the switch pops out very easy. #2:and this one kind of drove me crazy.luckily i have a spare parts maxxum 74 laying around. i had a problem with the motor coming on by itself(with the switch on intermittent).yoy may hear a buzz and/or clicking coming from the motor and/or foot pedal.the problem was in the switch that you step on(round button,has "MINN" on it.there's a little rubber cover over the switch button(underneath round "MINN" button).that little rubber cover gets a hole worn in it after alot of use.water gets down into the switch and it's shot.you'll have to replace the switch.it's an easy fix,2 screws hold it in and 2 screws hold the wires on. |
Disclosure / Disclaimer
Before acting on the content posted, you should know that BassFishin.Com may benefit financially and otherwise from content, advertising, links or otherwise from anything you click on, read, or look at on our website. Click here to read our Disclosure Policy and Disclaimer. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|