Bass Fishing HomeBass Fishing Forums

Go Back   BassFishin.Com Forums > Serious Conversation Only > Bass Boats, Trailers & Setups

Reply
 
Thread Tools Rate Thread Display Modes
Old 03-29-12, 07:54 PM   #1
bretmoua
BassFishin.Com Member
 
Join Date: Mar 2012
Posts: 3
Default Beeping noise 1996 Nitro Savage 884 with mercury 150 XR6

I have a 1996 Nitro Savage 884 with mercury 150hp XR6 2 stroke motor. I have replaced:
a. two thermostats
b. fuel filter
c. fuel pump
d. fuel line from tank to motor including bulb
d. water pump
After fixing it, it ran great for a whole week. After a week, it started to make a beep beep beep sound continuously if I run it past 10mph. If I slowly cruise under 10mph the sound won't come on. I have checked for water peeing out of the motor and it's doing that. Don't think the motor is over heating because it's peeing out water good. I also checked my oil level in the reservoir and noticed that it was a bit low. So I bought two quarts today and did a trial run at home. Had it in gear with a little gas going and the noise came back again. beep beep beep beep constantly. What can be the problem?

Last edited by bretmoua; 03-29-12 at 08:10 PM.
bretmoua is offline   Reply With Quote
Old 03-30-12, 12:35 PM   #2
bretmoua
BassFishin.Com Member
 
Join Date: Mar 2012
Posts: 3
Default

I guess a newbie gets no help.
bretmoua is offline   Reply With Quote
Old 03-30-12, 12:57 PM   #3
Bubba_Bruiser
BassFishin.Com Super Veteran
 
Bubba_Bruiser's Avatar
 
Join Date: Feb 2009
Location: South MS
Posts: 3,659
Send a message via MSN to Bubba_Bruiser
Default

Not a ton of boat mechanics around here, but with the weekend coming up, there will be some guys chime in.

Welcome to the place to be off the water. And by the way, "I guess a newbie gets no help." crap gets you no where in a hurry.
__________________
\,,,,/ ROCK ON! HRN4L!
Bubba_Bruiser is offline   Reply With Quote
Old 03-30-12, 01:15 PM   #4
bassboogieman
BassFishin.Com Super Veteran
 
bassboogieman's Avatar
 
Join Date: Feb 2006
Location: Parkesburg, Pa.
Posts: 3,636
Default

Sounds like an oil problem. Either the pump or the sensor in the oil injection system. I take care of my own routine engine maintence but I'm not a do-it-yourselfer when I have a problem with the outboard, I take mine to a mechanic. I understand they are not cheap but neither is blown engine due to a mis-diagnosis by myself or someone off he internet.
bassboogieman is offline   Reply With Quote
Old 03-30-12, 03:41 PM   #5
Tavery5
BassFishin.Com Super Veteran
 
Tavery5's Avatar
 
Join Date: Dec 2009
Location: Wichita, KS
Posts: 2,384
Default

I am not a boat mechanic but from what I know the alarm is most likely an overtemp alarm, you have replaced the thermostat and it sounds like your impellar is working. I would troubleshoot the sensor, take the wires loose from the sensor and use an ohm meter, you should have no continuity between the leads. If you have continuity, you have a shorted lead somwhere, if not, you may think about replaceing the sensor.
__________________
They call me Ishmael
Tavery5 is offline   Reply With Quote
Old 03-31-12, 06:55 PM   #6
MIbasser
BassFishin.Com Super Veteran
 
MIbasser's Avatar
 
Join Date: Feb 2008
Location: Okemos, MI
Posts: 1,440
Default

Is the motor oil injected or do you have to premix? I've heard the beep on mine and it was due to no oil (a little opps on my part).

But usually when it goes into "safe" mode, it's either over heating or no oil would be my guess.
MIbasser is offline   Reply With Quote
Old 04-10-12, 12:34 PM   #7
bretmoua
BassFishin.Com Member
 
Join Date: Mar 2012
Posts: 3
Default

Thanks guys. After carefully checking everything, I noticed that the oil reservoir on my motor was low on oil. So I added oil to both the tank on the motor and boat and bled the system. Now it's working great again and no more beep beep beep.
bretmoua is offline   Reply With Quote
Reply

Disclosure / Disclaimer
Before acting on the content posted, you should know that BassFishin.Com may benefit financially and otherwise from content, advertising, links or otherwise from anything you click on, read, or look at on our website. Click here to read our Disclosure Policy and Disclaimer.


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 09:34 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2014, vBulletin Solutions, Inc.
2013 BassFishin.Com LLC